Logo

C0152 Engine Trouble Code

Meaning of C0152 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C0152 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for C0152 code is occuring now you should check C0152 repair processes.
Now don't ask yourself; What should you do with C0152 code ?
The solution is here :

C0152 Possible Solution:

C0152 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

C0152 Code Meaning :

C 0 1 5 2
OBD-II Diagnostic Chassis (C) Trouble Code For Engine Intake Valve Control Solenoid Circuit Low Fuel Rail/System Pressure - Too High Cylinder 1 Injector Circuit Low Glow Plug/Heater Circuit 'A' Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C0152 OBD-II Diagnostic Chassis (C) Trouble Code Description

C0152 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction.

Main reason For C0152 Code

The reason of C0152 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

C0152 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.